| BBNovaRacing.com http://bbnovaracing.com/forum/ |
|
| intake porting http://bbnovaracing.com/forum/viewtopic.php?f=3&t=4231 |
Page 1 of 1 |
| Author: | jacobgiles [ Mar Sun 12, 2006 2:44 pm ] |
| Post subject: | intake porting |
i am going to port the runners on my victor jr intake to match a felpro 1205 gasket. im sure this is going to be a pian in the ass and take awhile. how far up inside the intake do i port? or would i just open the intake to match the gasket and smooth it out? does my question make any sense? 
|
|
| Author: | bbnova [ Mar Sun 12, 2006 6:26 pm ] |
| Post subject: | Re: intake porting |
I have all my stuff done for me.... I would think if the runner cross section isn't changed too much to match the gasket, an inch or less up the runner would be sufficent... jacobgiles wrote: i am going to port the runners on my victor jr intake to match a felpro 1205 gasket. im sure this is going to be a pian in the ass and take awhile. how far up inside the intake do i port? or would i just open the intake to match the gasket and smooth it out? does my question make any sense?
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|